Cleaning Eavestrough Toronto

Cleaning Eavestrough Toronto

1. Turn off the water supply to the eavestrough first. 2. Fill a clean 5 gal. bucket with enough soapy water to fill the eavestrough to a height of at least three feet. 3. Fill the bucket about half way with soapy water. Add enough of the soap solution to fill the bucket so that it’s warm and not too thin. 4. Fill the other half of the bucket with just cold water so it’s warm but not too hot. 5. The eavestroughs are small so a bucket like this is probably too small for large eavestroughs. For larger eavestroughs, you will probably need to use two buckets, one warmed and one not. 6. Soak the eavestrough in the soapy water for about 30 minutes. 7. Remove the eavestrough from the bucket and squeeze out as much water as possible. 8. Repeat steps 1-4 until you have drained the bucket completely. 9. With the eavestrough still in the bucket, repeat steps 7-9 again to drain out the soapy water and then repeat steps 1-4. 10. Allow the eavestrough to drain for 10 minutes or so. 11. Once the eavestrough is empty, allow it to drain for another 30 minutes or so. 12. This should get rid of most of the excess water. Be careful that any debris stuck to the inside of the eavestrough does not get stuck to the outside of the eavestrough. Once you have drained the last of the water, let the eavestrough drain for an additional 15 minutes. 13. With the eavestrough empty, it’s time to rinse it out with cold water and rinse off any accumulated leaves or debris. 14. Some eavestroughs may have drainpipes from a water main line that runs under the eavestrough. If that is the case, you will need to have that pipe removed so the eavestrough can drain. It may take some time to get this done.

Cleaning Eavestrough Toronto

We welcome your comments!